Search

Site Map

Install the Label Peeler

This printer is compatible with the Label Peeler (PA-LP-007).

Parts Description

Label Peeler Assembly

Label Peeler Assembly

Screws (2 each)

Screws (2 each)
  1. Push the Roll Cover Release Lever to open the Roll Compartment Cover.
    image
    1. Roll Cover Release Lever
  2. Remove the standard platen and holder unit by removing the four screws shown in the illustration.
    image
    CAUTION
    • Do not touch the blade when removing the standard platen.
    • Do not touch the tear bar when removing the holder unit.
    image
    Recommended tightening torque: 0.55±0.049 N·m.
  3. Install the platen and holder unit, and fasten them using the four screws supplied with the Label Peeler.
    image
    image
    The upper tear bar and lower tear bar cannot be used when the Label Peeler is installed.
  4. Peel off a few labels. Then, set the Roll so that the next label does not cover the Media Sensor area.
    image
    1. Media sensor
  5. Close the Roll Compartment Cover.
  6. Lightly pull on the paper in the Paper Exit Slot to remove any slack in the roll.
    image
    IMPORTANT
    • Before using the Label Peeler, specify the following settings:
      • Set Exit Position to Peeler in the Basic tab of the Printer Setting Tool.
      • Select the Use Peeler Function check box on the Basic tab of the printer driver properties. For more information, see Related Topics.
    • When not using the Label Peeler, specify the following settings:
      • Set Exit Position to [Tear Bar] in the Basic tab of the Printer Setting Tool.
      • Clear the Use Peeler Function check box on the Basic tab of the printer driver properties.
  7. Set Exit Position to Peeler in the Basic tab of the Printer Setting Tool.
    NOTE
    • When Peeler is set to Exit Position, [Tear Bar] in [Settings] and [Auto Detect] in [Media] cannot be selected on the printer's LCD.
    • For best performance, make sure the paper's head margin is at least 3 mm.
    • When using the Label Peeler, paper dust may stick to the print head. Clean the print head regularly. For more information, see Related Topics:
    • Use the latest firmware when printing with the Label Peeler.
Related Information
Did you find the information you needed?

find moreaccept