Search

Site Map

Home > Appendix > Optional Accessories > Charging Cradle (Optional: PA-CR-005) > Mount the Charging Cradle on the Wall

Mount the Charging Cradle on the Wall

  1. Drill four holes in a commercially available board according to the spacing of the screw holes of the Charging Cradle.
    image
    1. Height: 30 mm
    2. Width: 38.1 mm
  2. Affix the Charging Cradle to the board using four screws, as shown in the illustration.
    image
    image
    • Make sure you install the Charging Cradle in the correct direction so that the printer will not fall.
    • Use M5 size screws.
  3. Lean the board against the wall or secure the board to the wall.
Related Information
Did you find the information you needed?

find moreaccept